| 1. | Check the length thickness ratio of the plastic flow
检查塑料流动的长度厚度之比 |
| 2. | Relocate and or modify gate size width thickness ratio or gate land
重新放置浇口位置和或修改其尺寸宽厚度比 |
| 3. | Thickness ratio of rudder
舵的厚度比 |
| 4. | Determinaton of cotton maturity coefficient by lumen width - cell wall thickness ratio method
中腔胞壁比值法测定棉纤维成熟度系数的讨论 |
| 5. | Effects of the plates width - thickness ratios on cyclic characteristics of i - section steel beam - columns
板件宽厚比对高层钢结构压弯构件滞回性能的影响 |
| 6. | Since the plate is relatively wider and the width - thickness ratio of plate is always larger , the section of cold - formed steel is easy to buckle
由于冷弯型钢截面开展，各组成板件的宽厚比往往较大，截面容易凸曲。 |
| 7. | The chinese codes stipulate both the width - thickness ratio and the minimum thickness of the elements . that is stricter than the stipulations of north american codes
对于受压板件的壁厚，我国规范采取的是既限制板件宽厚比又限制最小板厚的规定，其限制较北美同类规范偏严。 |
| 8. | The shape of the fender is composed of three inter - vertical planes , which were only 3mm thick , but the length is more than 200mm . so it is a complicate product with superior length / thickness ratio
该挡泥板由三个相互垂直面组成，产品厚度仅为3mm ，但高度最大达到了约200mm ，是一种超高度厚度比的复杂制品。 |
| 9. | The national steel structure design code ( gbj17 - 88 ) is not permitted the b / t exceed ( 10 + 0 . 1 ) 235 / fy . the width - thickness ratio of the web ( b / t for short ) exceed the limitation often
钢结构设计规范( gbj17 - 88 )规定t形截面轴压构件腹板宽厚比不应超过( 10 + 0 . 1 ) ，按国家标准生产的t型钢的腹板宽厚比大多超过限值。 |
| 10. | Through these studies , preliminary results and understandings have been gained as follows : 1 ) propose a reverse - appraisal method that is more reliable based on imaging well log data to classify the lava flow orientations of volcanic rock facies , integrating with lava - debris thickness ratio
通过研究，初步获得的成果和认识如下： 1提出了依据成像测井资料，划分火山岩岩相的熔岩流向反推法，结合火山熔岩与碎屑岩厚度比法，划分结果更可靠。 |
